¶ Overview
Telemetry automated monitoring node (AMN) that interfaces with sensors.
¶ Breakdown
¶ Connectors
This is the sensor connector. To insert a wire, firmly push the wire into the port until it is fully seated. To remove a wire, use a small flathead screwdriver to push down the white pad adjacent to the port that contains the wire you wish to remove.
This is the micro USB port. It can be used to interface with the AMN from a computer and it can also be used for charging.
This is the battery connector. It is rated for a 3.7V battery.
These connectors are used for interfacing with cellular modems.
This is the WiFi antenna connector.
This is the solar panel power connector.
This is the connector for the status lights on the top of the AMN.
¶ Buttons and Switches
This is the power switch. This switch only controls battery power and will not turn off the unit if it is plugged in by USB.
This is the reset button.
This is the bootload button. It is used for loading software onto the AMN.
¶ Lights
This is the status light. It will blink green while the AMN is running and not in sleep mode.
This is the alert light. It will turn solid red if the AMN has encountered an error.